FORD SPECIALIST
Ford Module Programming
PCM, PATS & BCM via Remote J2534 — Ford IDS
Ford's IDS (Integrated Diagnostic Software) is our primary tool for Ford module work. Whether you're replacing a PCM, doing a PATS relearn after a used module swap, or updating BCM parameters, we handle it remotely through your J2534 device.
What We Cover
- PCM Reprogramming (IDS)
- PATS Relearn & Key Enrollment
- BCM Programming & Security Transfer
- ABS Module Configuration
- Transmission Control Module
- PMI (Product Module Integration)
How It Works
- Call with the VIN. We confirm the Ford IDS procedure and quote.
- Connect battery maintainer. J2534 plugged into OBD-II port.
- Open AnyDesk and share your session ID.
- We connect via Flexihub and run IDS using your J2534 as the passthru interface.
- Programming completes. We confirm PATS status and provide key cycle instructions.
Frequently Asked Questions
What Ford models do you cover?
Most Ford, Lincoln, and Mercury vehicles from 2004 onward with PATS. Coverage varies by model — call with the VIN to confirm.
What J2534 device works with Ford IDS?
Autel J2534, Drew Tech MongoosePro, and OBD Solutions J2534 are all compatible. Call if you're unsure about your device.
Can you do a used PCM swap on a Ford?
Yes. Ford PCMs require a VIN write and PATS registration during swap — we handle both during the session.
What if the PATS doesn't complete?
We stay on the session until confirmed successful. If a reset or additional key cycle is needed, we walk you through it live.
Ready to Book a Session?
Call with the VIN and module — we confirm coverage and quote before you start.